What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 03:45

In schematic diagrams this is the symbol for a fuse:
(Dc diagram shown, AC is similar).
[old diagram got deleted by accident]
Would you raise your children like your parents raised you?
These devices are installed between the “hot” and “neutral” and protective ground.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
These are simplified answers to the original question, and does not change anything I wrote above.
What Makes the Florida Panthers Special? Gaudreau Tribute a Fine Example - Florida Hockey Now
This one hit behind the barn.
At one ohm, the resistor has a maximum of 1 watt power.
a photo is worth a thousand words.
Apple drops a spot on 2025 Fortune 500 list - 9to5Mac
Here is a simplified AC power diagram.
What does a fuse do?
What is lightning?
Trump asks Congress to pull $9.4 billion in funding for NPR, PBS and foreign aid - Axios
This is where this question deviates from being a 'generic' question, and becomes more specific.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
There are three different concepts here that are getting confused.
7 Best High-Volume Foods for Weight Loss, According to Dietitians - AOL.com
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
He then describes the function of a fuse.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
[image of Common-mode choke]
what exactly is a ‘surge’ protector?
This device then solves the entire problem.
An AC voltage/ current source, and an ac inductive load.
Barnstars:
Why do many women wear sleeveless shirts, more so than men?
The MOV will conduct when the voltage exceeds 50% of line voltage.
One
It also is a device that limits the change in current flow.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The third is lightning and “how it gets conducted into a home.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Confirmed rabies case in Fayetteville after fox bites home inspector - WRAL.com
A circuit breaker is similar, but is resettable.
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is 'the assistant's answer'
A fuse is a non-resetable over current circuit protector.
At least they know the answer if they wanted it.
Even Captain James T. Kirk was trapped in a woman's body. Don't you think he'd support trans people?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
the problem then depends on "how fast does the fuse operate?".
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Cognitive changes before DBS not a dementia risk factor in Parkinson’s - Parkinson's News Today
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Upvotes:
but this device (an Inductor) … impedes the rapid changes in the current.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
I post the exact comment here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Now when you have a certain ac resistance, then a current flows in a loop.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Edit 2024–10.
So, the voltage could go up to 500 volts, and the fuse will not open up.
nine
The bolt then partially travels down the line to your home.
He then describes Rainy Season and Lightning.
But it can get overloaded, and no longer works.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
eight
The other is “what does a “fuse” do?”
But… the neutral is now “floating” because of the 1 ohm resistance.
so, what happens?
First Sentence:
He then asserts :
It seems Mohan does not understand the difference between a comment and an Answer.
For this case there are devices called Metal oxide varistors (MOV).
but I think this circuit , shows a few more pieces.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is where the MOV conducts again, and dissipated the energy.
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–10[John johnson John Johnson ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
There are two important concepts here.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi